







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Kitchen Remodeling in Frisco: What to Know First
Penhallow Remodeling Frisco provides independent KraftMaid kitchen remodeling in Frisco, typically completing a full kitchen between four and eight weeks from signed scope to final walkthrough. A full KraftMaid kitchen remodel here usually lands between $14,000 and $45,000, and we put that number in writing before anyone picks up a pry bar. This page is for Frisco homeowners who already have KraftMaid cabinets or are planning a KraftMaid kitchen and want a contractor who knows the product line, not one who’ll treat the name as a logo on an estimate.
We’re a general contractor working as an independent KraftMaid service provider. We’re not affiliated with or authorized by KraftMaid. Call (833) 954-5757 for a free estimate.
How KraftMaid Products Fail – and How We Fix Them
KraftMaid builds a solid cabinet, but twenty years of Texas humidity takes a toll on any wood product. In Frisco, we see particular patterns tied to particular KraftMaid construction methods.
- Particleboard core swelling on the base cabinets near the sink (Vantage line). The Vantage series uses a particleboard box, which is fine until a slow under-sink leak wets it. The panel swells, the cabinet toe kick kicks off, and the door hinge drills out of its holes. We replace the affected box with plywood and rehang the original door if the finish survived. If it didn’t, we match the door from KraftMaid’s current catalogue.
- Face-frame joints separating from steam (Waypoint line). Five to eight years of dishwasher venting into the room lifts the mitered face-frame joints at the sink run first. The glue line weakens and the frame lifts 1/16 inch. We clamp, glue and pin the joint, then refinish. Left alone, the gap grows and catches dirt and moisture.
- Drawer-box dovetail failure above the oven (Premier series). Heavy cookware in a wide drawer over a wall oven cycles it through hundreds of thermal expansions. The dovetail pins work loose. KraftMaid offers a plywood upgrade box; we source that box when the original fails, which is faster than rebuilding the joint.
- Soft-close hinge sag on the pantry doors (Classic series). The soft-close hinge on a heavy tall pantry door wears faster in the Frisco climate than the door itself. We replace with the current OEM hinge because the aftermarket version loses its soft-close action in two to three years.
- Cabinet-to-wall gap opening at the soffit (any wood-door line). Frisco slab homes settle slightly in the first ten years, and the gap between cabinet top and soffit widens. We shim and refasten the run rather than caulk over the gap, because caulk shrinks in a year.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Our KraftMaid Kitchen Remodeling Process
- 1
In-home assessment. We inspect every KraftMaid box, door, drawer, and hinge across the kitchen. We look at plumbing, venting, and the wall behind the cabinets.
- 2
Written scope and price. You get a line-item written price before any work starts. It covers the demo, any cabinet repairs or replacements, countertop, backsplash, flooring, and labor. That’s the number on your invoice.
- 3
OEM vs. aftermarket decision. For hinges, drawer slides, and door fronts, we default to KraftMaid OEM unless a documented equivalent is better. Countertops run Cambria, Silestone or Caesarstone. Fixtures come from Kohler or Moen.
- 4
Install and remodel. Background-checked, uniformed technicians show up in the arrival window we gave you. We work to keep the kitchen usable as long as possible.
- 5
Test and walkthrough. Every door opens, every drawer pulls, every soft-close closes silently. You walk through the finished kitchen with us before we leave.
- 6
365-Day Done Right Promise. If anything we touched fails in the first year, we come back and fix it at no charge. That’s in writing.
See the difference
Before
After
Before
After
Before
AfterWhat KraftMaid Kitchen Remodeling Costs in Frisco

Frisco KraftMaid kitchen costs break down by scope. These are the ranges we quote after an in-home assessment:
- Full KraftMaid kitchen remodel: $14,000 – $45,000
- Small or partial kraft maid kitchen remodel: $9,000 – $20,000
- KraftMaid cabinet installation: $4,000 – $13,000
- Countertop installation (Cambria, Silestone, Caesarstone): $2,000 – $6,500
- Backsplash installation: $800 – $2,500
- Kitchen island installation: $3,000 – $10,000
What pushes a KraftMaid job to the top of that range: cabinet-line upgrades (the KraftMaid plywood-box lines cost more than the particleboard Vantage), quartz countertops at a Cambria price point, and any plumbing or electrical relocation that goes with the layout change. Remodeling a bathroom at the same time typically runs $9,000 – $28,000, and we quote it separately so you can see the split. Call (833) 954-5757 for a free estimate; every quote is written before we start.
Why Frisco Homeowners Call Penhallow Remodeling Frisco for KraftMaid Work
We operate to The Kingswell Way: say the price before the work, show up in the window we gave, and leave the place cleaner than we found it. That standard gets applied to every KraftMaid job in Frisco we take on.
The guarantee is in writing on every project. If the work fails inside the first year, we come back and fix it at no charge. We answer the phone live, 24/7, with a real person you can talk to about a KraftMaid cabinet order status or a question about your countertop sealer.
Our technicians know the KraftMaid lines that show up most in Frisco kitchens, and they know the difference between a Vantage box and a Premier drawer. Alongside KraftMaid, we also work with Kohler, Cambria, Toto and Silestone so a single contractor can carry the kitchen through cabinets, countertops and fixtures.
FAQs

No, assuming the work doesn’t alter the cabinet structure. KraftMaid’s warranty covers the original product against defects; our labor and installation are covered by our own 365-Day Done Right Promise. If we replace a failed KraftMaid part with an OEM part, the KraftMaid warranty on that part continues.
Yes. We source KraftMaid OEM doors, hinges, drawer slides, and cabinet boxes through authorized distributors. Most replacement doors arrive in two to four weeks. Sourcing through non-authorized channels often brings a cheaper part that fails in half the time, so we don’t.
Repair is usually the right answer if the cabinet boxes are structurally sound and only the doors, hinges or drawer slides have failed. Replace when three or more boxes have water damage, when the frame has separated along the whole run, or when the layout no longer fits the room. We tell you which one it is in the written scope.
Four to eight weeks for a full kitchen, seven to fourteen days for a partial remodel that only touches cabinets, countertops, or backsplash. Cabinet orders from KraftMaid take two to four weeks to arrive; that’s typically the deciding factor in the schedule.
Yes, when the scope triggers one. Cabinet swaps alone usually don’t require a permit; moving plumbing, electrical or load-bearing walls does. We pull the permits and pass the inspections, and the permit cost is in the written price.
Call (833) 954-5757 to schedule a free estimate. We’ll walk your KraftMaid kitchen, measure what needs measuring, and hand you a written price before any work starts.
Written by the team at Penhallow Remodeling Frisco, serving Frisco and nearby areas.












