







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Kohler Kitchen Remodeling in Frisco: What to Know First
Penhallow Remodeling Frisco provides independent Kohler kitchen remodeling in Frisco, and most full kitchens we handle take three to six weeks from demo to final walkthrough. As an independent Kohler service provider, we’re not affiliated with or authorized by Kohler, but we install and work around Kohler fixtures, sinks and faucets every week, and we put the price in writing before any work starts. A full kitchen remodel in Frisco typically runs $14,000 – $45,000 depending on layout, cabinet line and countertop material.
This page is for Frisco homeowners who already own Kohler products (a farmhouse sink, a pull-down faucet, a filtered-water tap) and want a kitchen that’s built around them, not replaced around a generic spec. Call (833) 954-5757 for a free estimate.
How Kohler Products Fail – and How We Fix Them
Kohler makes solid products. But Frisco’s climate and hard water are hard on kitchen fittings, and some failure modes are specific to certain lines. Here’s what we actually see, and what we do about it.
- Cartridge wear in Kohler pull-down faucets (the Simplice and Bellera lines especially). The ceramic cartridge inside these faucets wears down over years of use, and you’ll notice it as a faucet that drips at the base or one that gets stiff to turn. Frisco’s water is on the harder side, and mineral buildup accelerates that wear. We replace the cartridge with a Kohler OEM part rather than a cheaper aftermarket one, because the aftermarket cartridges we’ve pulled out of Frisco kitchens tend to fail again within a year or two.
- Finish wear on Vibrant Stainless and Vibrant Brushed Moderne finishes. Kohler’s Vibrant finishes are multi-layer, and they hold up well under normal use. What kills them is abrasive cleaner. We regularly see dulled or scratched faucet finishes in Frisco homes where a scouring pad got used once. When we’re remodeling around a Kohler faucet, we spec a finish-safe cleaner and note it in the handoff.
- Undermount sink separation in Kohler cast iron and enameled sinks. Cast iron is heavy, and if the original installer used clips alone without a proper support rail, the sink can shift or separate from the counter over time. We re-set these with a full support frame and silicone bedding, which is the method Kohler’s own installation guidance calls for.
- Filtered-water faucet cartridge clogging. Kohler’s filtration faucets use a small cartridge that clogs faster than most homeowners expect, especially with harder water. We swap the filter cartridge during any kitchen remodel so you’re starting fresh, and we show you where it is and how to change it.
- Garbage disposal flange corrosion where a Kohler sink meets a standard disposal. The stainless flange on most disposals will corrode against a cast-iron sink over years. When we remodel, we seat the flange with plumber’s putty rated for the application and check the seal during the final test.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Our Kohler Kitchen Remodeling Process
Every Kohler job follows the same six steps, and the price you get in step one is the price on the final invoice.
- 1
Free in-home estimate and fixture walkthrough. We look at what Kohler products you have, measure the space, and talk through what stays and what goes. You get a written price before we leave, not a range and not a verbal ballpark.
- 2
Written scope and product selection. We confirm the Kohler fixtures staying in place, the new cabinet line (KraftMaid and Wellborn are our standards), and the countertop material. You see the number in writing, with line items.
- 3
OEM vs. aftermarket parts decision. For any Kohler fixture being serviced rather than replaced, we quote the OEM cartridge or valve and explain the trade-off against a quality aftermarket part. You decide, and it’s in the written scope.
- 4
Demo and substrate prep. Cabinets come out, the cement board substrate (the moisture-resistant layer behind tile) goes in where required, and the job site gets a daily cleanup. Our technicians are background-checked and arrive in uniform.
- 5
Install and test. Cabinets, countertops, backsplash, Kohler sink and faucet re-set, disposal flange checked. We run every fixture and check for drips before we call it done.
- 6
Final walkthrough and the guarantee. You walk the kitchen with us, we hand over the written guarantee, and the 365-Day Done Right Promise covers the work. If something fails inside the year, we come back and fix it at no charge.
See the difference
Before
After
Before
After
Before
AfterWhat Kohler Kitchen Remodeling Costs in Frisco

Here’s what a Kohler kitchen project actually runs in Frisco, broken out by scope:
| Project | Typical range |
|---|---|
| Full kitchen remodel | $14,000 – $45,000 |
| Small or partial kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What moves the number most is cabinet line (a semi-custom KraftMaid runs meaningfully higher than a stock line), countertop material (Cambria quartz sits above Silestone, and both sit above laminate), and whether the Kohler sink and faucet you’re keeping need to come out and go back in. Layout changes that move plumbing or gas push the number up too.
Call (833) 954-5757 for your free estimate. A live person answers 24/7, and the price you get is in writing before work starts.
Why Frisco Homeowners Call Penhallow Remodeling Frisco for Kohler Work
Most of our Frisco customers have been burned before. They’ve had a contractor give a verbal number that grew after demo, or a crew that didn’t show on the day it promised. We built our process around removing those two risks: a written price before work starts, and a written guarantee on every project. That’s The Kingswell Way, and it’s simple: say the price before the work, show up in the window we gave, leave the place cleaner than we found it.
Our technicians have up to 22 years of experience, including Kohler-specific fixture work, and the 365-Day Done Right Promise means if something fails inside the year we come back and fix it free. We’re not a single-brand shop either. We also install KraftMaid and Wellborn cabinetry, Cambria, Silestone and Caesarstone countertops, and Toto fixtures when a Frisco homeowner wants options.
FAQs

It can, if the work is done incorrectly or the wrong parts are used. Kohler’s warranty covers manufacturing defects, and using OEM parts and following Kohler’s installation guidance keeps that coverage intact. We install Kohler fixtures per the manufacturer’s spec, and we note in writing what we did so there’s a record if a warranty claim ever comes up.
Often, yes. Kohler keeps parts for many discontinued lines, and we can usually source an OEM cartridge or valve even when the faucet is no longer sold. When an OEM part isn’t available, we quote a quality aftermarket equivalent and tell you plainly what you’re giving up in longevity. Call (833) 954-5757 and we’ll check availability for your model before you decide anything.
Repair, usually, if the body and finish are in good shape. A cartridge replacement is a fraction of a new faucet, and a Kohler faucet with a solid body lasts decades. Replace if the finish is worn through or the body is cracked. We’ll tell you which side you’re on after we look at it.
Three to six weeks for a full kitchen, start to final walkthrough, and one to two weeks for a partial remodel or cabinet install. Layout changes and custom cabinets push it toward the longer end. We give you the schedule in writing with the price, and we don’t start until you’ve signed off on both.
No. Your written price is the price on the final invoice. If we find something behind the wall (water damage, old wiring) that you didn’t know about, we stop, show you, quote the additional work in writing, and wait for your approval before proceeding. You never get a surprise number.
Ready to price your Kohler kitchen project? Call Penhallow Remodeling Frisco at (833) 954-5757 for a free in-home estimate. A real person answers 24/7, the price comes in writing, and the 365-Day Done Right Promise backs the work.
Written by the team at Penhallow Remodeling Frisco, serving Frisco and nearby areas.












